Optional accessories
A3000 Series active probes with Intelligent Probe Interface
The Pico A3000 Series are high-impedance active oscilloscope probes. They have been designed to have minimal impact on the signal being probed with maximum signal transfer to the PicoScope 6000E Series via the intelligent probe interface. Their ergonomic design allows for comfortable handheld use with the addition of a button to start and pause capturing in PicoScope 6.
Features
Up to 1.3 GHz probe bandwidth
Click-to-fit convenience
Super light flexible cable
Control capture start and stop using a button on the probe
Connects directly to PicoScope 6000E Series oscilloscopes with the Intelligent Probe Interface
Powered by the oscilloscope, eliminating separate power supplies and interface boxes
Automatic probe detection and unit scaling
LED status indicator
TA369 MSO pod
The PicoScope 6000E Series can be upgraded to MSO capability. This consists of a detachable active MSO pod, powered by the scope, with eight permanently attached flying leads terminating in MSO probes for connection to the circuit under test.
Features:
8 digital inputs per pod
500 MHz bandwidth, 1 Gb/s
5 GS/s sampling on 16 digital channels
1 ns minimum pulse width
Minimal load on the device under test: 101 kΩ ∥ 3.5 pF
Innovative ground clips for easy connection to 2-row, 2.54 mm-pitch headers
8 ground leads and 12 mini test hooks included
Probe positioning system
The Pico oscilloscope probe positioning system holds your circuit board firmly during soldering, inspection and test.The kits include flexible probe holders which secure magnetically to the steel base plate. When the probes are installed in the holders they can be positioned to make contact with points of interest on the circuit board and will remain in contact while you make measurements in the PicoScope software.The large steel base plate is mirror-finished allowing you to see any items such as status LEDs underneath the PCB.Probe positioning system kit contents:ItemPQ215 kitPQ219 kitPQ218 kit
Passive analog high-impedance probes
P2056 500 MHz and P2036 300 MHz passive probes are supplied with your scope and are also available separately in single or dual packs. These probes feature a probe-detect readout BNC connector allowing automatic recognition as a 10:1 attenuator by the scope.Probe connection is confirmed by a notification in PicoScope 6.
Features:
Up to 500 MHz bandwidth
10:1 attenuation
High-frequency response trimmed to match the oscilloscope
Probe-detect readout pin for automatic range scaling